Symbols
The followings show the symbols used for tool.
･volts
･amperes
･hertz
･ alternating current
･no load speed
･ revolutions or reciprocation per minute
FUNCTIONAL DESCRIPTION
CAUTION:
•Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool.
Adjusting depth of cut
1. Lever
1
007393
CAUTION:
•After adjusting the depth of cut, always tighten the lever securely.
Loosen the lever on the depth guide and move the base up or down. At the desired depth of cut, secure the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more than one blade tooth projects below workpiece. Using proper cut depth helps to reduce potential for dangerous KICKBACKS which can cause personal injury.
Bevel cutting
Positive stopper
22.5 | 51.5 | 1 |
|
|
45
51.5
22.5
45
2
007394
1.Lever
2.Positive stopper
Turn the positive stopper so that the arrow on it points one of three positions (22.5°,45°,51.5°). Then, tilt the tool base until it stops and secure the base with the lever. At this time, the same angle as the one that the arrow points is obtained.
Setting bevel angle
Loosen the lever and tentatively set the tool base at the 0°bevel angle, then tighten the lever securely.
Turn the positive stopper so that the arrow on it points one of three positions (22.5°,45°,51.5°) that is equal to or greater than the desired bevel angle.
Loosen the lever again and then tilt and secure the tool base at the desired angle securely.
7
