Makita 5680DWB Removing or installing the saw blade, Be Sure to Tighten the Bolt Securely

*If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge from the high capacity battery charger.

*If the charging light flashes alternately in green and red color, a problem exists and charg ing is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.

Removing or installing the saw blade

CAUTION:

Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the blade.

To remove the blade, press the shaft lock so that the blade cannot revolve and use the hex wrench to loosen the bolt clock- wise. Then remove the bolt, outer flange and blade.

	:wrench
I	I
	Fig. 10

To install the blade, follow the removal pro- cedure in reverse.

BE SURE TO TIGHTEN THE BOLT SECURELY.

Saw blade

Fig. 11

CAUTlON:

*Be sure the blade is installed with teeth pointing up at the front of the tool *Use only the Makita hex wrench to install or remove the blade.

12