![Selecting correct Phillips bit](/images/new-backgrounds/197598/19759813x1.webp)
Selecting correct Phillips bit
Use the chart to determine the best size driver bit for the size of screw that you wish to use.
Selecting slotted bit
| Nominal diameter (mm) |
Bit N o . | Wood screw |
2.1- 2.7 (3/32"- 1/8")
No . 2 3.1 - 4.5 (118"- 3/16")
Use a slotted bit that properly fits the screw slot. Use of a bit that is too small will damage the screw and/or bit.
Installing or removing driver bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit.
To install the bit, place it in the chuck as I far as it will go. Tighten the chuck by hand. Place the chuck key in each of the three holes and tighten clockwise.
Be sure to tighten all three chuck holes evenI y .
To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand.
I
Tighten
I Chuck k e y
7