| 001760 |
1 | 2 |
| |
3 | 4 |
1.Red mark
2.Screw
3.Number
4.Adjusting ring
ASSEMBLY
Overload protector
The overload protector automatically cuts out to break the circuit whenever heavy work is prolonged. Wait 20 - 30 sec- onds before resuming operation.
Adjusting the fastening torque
The fastening torque can be adjusted infinitely from approx. 5 kg·cm (0.4 ft·lbs) to 37 kg·cm (2.7 ft·lbs). To adjust it, loosen the two screws and turn the adjusting ring. Then tighten the screws to secure the adjusting ring.
Refer to the table for relation between the numbers on the adjusting ring and the fastening torque to be obtained.
|
| 001763 | |
Numbers on | Fastening torque to | ||
| |||
adjusting ring | be obtained |
| |
1 | 5 kg·cm (0.4 ft·lbs) |
| |
2 | 10 kg·cm (0.8 ft·lbs) |
| |
3 | 18 kg·cm (1.3 ft·lbs) |
| |
4 | 27 kg·cm (1.9 ft·lbs) |
| |
5 | 37 kg·cm (2.7 ft·lbs) |
|
Example:
10kg·cm (0.8 ft·lbs) of fastening torque can be obtained when the number 2 is aligned to the red mark.
NOTE:
•Always tighten the two screws to secure the adjusting ring after adjusting the fastening torque.
CAUTION:
•Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool.
11
