Removing or installing t h e outer and inner sleeves
CAUTION :
*Always be sure that the tool is switched off and unplugged before removing or installing the outer and inner sleeves.
Be careful not to allow foreign matter to enter the insides of the tool when removing or installing the outer and inner sleeves.
The outer sleeve M20 and inner sleeve 3/4" are
If you need other sizes for your work, replace the sleeves as follows.
Loosen the two screws while holding the |
| =\ \ - |
outer sleeve. The outer and inner sleeves | I | |
will be pushed up by the springs built into | ||
the tool. |
Press the pin down to remove the inner sleeve from the outer sleeve. Be careful not to drop the inner sleeve when removing it. Do not remove the inner sleeve spring, tip rod and tip rod spring from the tool.
Inner sleeve |
Hold the inner sleeve with the pin facing upward. Place the outer sleeve over the inner sleeve. Press the pin to secure the inner sleeve.
Inner sleeve spring
Outer sleeve
in
sleeve
5
