Insert the outer and inner sleeves into the tool while rotating the inner sleeve alternately clockwise and counterclockwise until there is no gap between the outer sleeve and the tool. See the figure below. Then tighten the two screws securely.
Switch action
To start the tool, simply pull the trigger. Release the trigger to stop.
C A U T I O N :
Before plugging in the tool, always check to see that the trigger switch actuates proper- ly and returns to the “OFF” position when released.
Bolt installation
Slip the tool onto the bolt so that the inner sleeve completely covers the bolt tip.
CAUTION :
Be careful when fitting the sleeve onto the bolt tip. Striking the tip can damage i t so that it will no longer fit inside the sleeve properly.
Keep forward pressure on the tool while
sliding it further forward until the outersleeve sleeve fits completely over the nut. If the
tool fails to fit completely over the nut, twist the tool slightly right and left while pushing forward.
Pull the trigger switch. The outer sleeve turns to begin tightening the nut.
6
