the tool, causing injury to you or someone around you.
• Do not use force when inserting the battery |
Selecting the action mode
Rotation with hammering
cartridge. If the cartridge does not slide in easily, it |
is not being inserted correctly. |
Switch action
12
1. | Rotation with |
| hammering |
2. | Lock button |
3. | Pointer |
4. | Change lever |
1
003104
1. Switch trigger
3
4
003128
For drilling in concrete, masonry, etc., depress the lock button and rotate the change lever so that the pointer points to the
symbol. Use a
Rotation only
CAUTION:
•Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop.
Reversing switch action
1
2
003131
1.Rotation only
2.Pointer
1 | 1. Reversing switch | |
lever | ||
| ||
A | B |
For drilling in wood, metal or plastic materials, depress the lock button and rotate the change lever so that the
pointer points to the 
symbol. Use a twist drill bit or wood bit.
Hammering only
003113 |
This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation.
When the reversing switch lever is in the neutral position,
1
2
003133
1.Hammering only
2.Pointer
the switch trigger cannot be pulled.
CAUTION:
•Always check the direction of rotation before operation.
•Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool.
•When not operating the tool, always set the reversing switch lever to the neutral position.
For chipping, scaling or demolition operations, depress the lock button and rotate the change lever so that the pointer points to the 
symbol. Use a bull point, cold chisel, scaling chisel, etc.
CAUTION:
•Do not rotate the change lever when the tool is running. The tool will be damaged.
•To avoid rapid wear on the mode change mechanism, be sure that the change lever is always positively located in one of the three action mode positions.
6
