Repair
P 3/ 14
[4]DISASSEMBLY/ASSEMBLY
DISASSEMBLING
(1)Disconnect lead wire and grounding wire by removing each connector after Air cleaner cover is removed. (Fig. 1)
(2)Remove Control cable from Insulator by loosening nuts of the adjust screw and disconnecting inner cable from Swivel of Carburetor. (Fig. 2)
Fig. 1
Connector (4pcs.) |
Fig. 2
Inner cable | Swivel | |
of Control | Adjust screw of | |
cable | ||
Control cable | ||
| ||
Cable | Nuts of Control | |
holder of | cable | |
Insulator |
|
(3)Loosen two M5x18 Hex socket head bolts on Pipe holder and remove M5x12 Hex socket head bolt. (Fig. 3)
(4)Pull out Shaft pipe complete from Engine (Pipe holder). (Fig. 4)
Note: Cover cloth on a shaft and pull out it by grasping it with Waterpump pliers in case the shaft is stuck at the spline engagement. (Fig. 5).
Fig. 3
M5x13 Hex. socket head bolt
M5x18 Hex. |
|
socket head bolt (2pcs.) | Pipe holder |
Fig. 5
| cloth |
Shaft | Water pump pliers |
ASSEMBLING |
|
Fig. 4
Shaft pipe | Shaft |
| Pipe holder |
Shaft pipe complete |
Take the reverse step of disassembly. Set Control cable in place. (Fig. 2, Fig. 6)
Fig. 6
Hook the tip end of Inner cable in the groove of Swivel on Carburetor and
fix Control cable in the Cable holder of Insulator by tightening Nuts of Control cable. Note: Adjust the tension of the cable to allow the play 1mm to 2mm.
Tip end of Inner cable to be hooked
on SwivelInsulator Swivel Adjust screw
| Inner cable |
| Nuts to fix |
| in Cable holder |
Control cable | of Insulator |
|