Repair
P 4/ 14
[4]DISASSEMBLY/ASSEMBLY
DISASSEMBLING
(1)Loosen two M5x25 Hex socket head bolts and remove Clamp cover B and Loop handle. (Fig. 7)
(2)Remove 4x18 Tapping screws (4pcs) and M5x14 Hex socket head bolts, then separate Lever case R and L. (Fig. 8)
Fig. 7 | Fig. 8 |
M5x25 Hex. socket |
head bolt (2pcs.) |
Shaft pipe |
complete |
Loop handle |
Clamp cover B |
Lever case set
M5x14 Hex socket head bolt (2pcs.)
4x18 Tapping screw (4pcs)
(3)Disassemble Shaft pipe complete by following the disassembly step of the chapter
(4)Pull out a shaft from Shaft pipe complete.
ASSEMBLING
Take the disassembling step in reverse.
[4]DISASSEMBLY/ASSEMBLY
DISASSEMBLING
(1)Disassemble Protector and Head case complete. (Fig. 9)
Fig. 9
1.Disassemble Protector by removing
Hex bolt (2pcs) and Hex socket bolt (1pc).
2.Insert 1R308 in a hole on Cutter holder to lock shaft and remove Cutter assembly by turning it clockwise.
3.Loosen M5x25 Hex socket head bolt and remove Head case complete.
Shaft pipe |
|
|
|
complete |
| M5x25 | Shaft pipe |
Protector | Hex socket | complete | |
| head bolt | Hex socket |
|
| head bolt |
| |
|
|
|
Head case complete
Hex bolt 1R308
Cutter assembly
Cutter holder