Makita HR2611F instruction manual Dust cup, Installing or removing the dust cup, Symbol, Cup

1	1. Lock button
010718

Adjust the depth gauge to the desired depth by moving it back and forth while pressing the lock button. After the adjustment, release the lock button to lock the depth gauge.

2	1. Toothed side of
	hex hole
	marking on the
	grip base
	2. Toothed side of
1	the depth gauge
010719
NOTE:

•Inserting the depth gauge with its toothed side not directed to the toothed side of hex hole marking on the grip base as shown in the figure does not allow the depth gauge to be locked.

Dust cup

1. Dust cup

1

010731

Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations. Attach the dust cup to the bit as shown in the figure. The size of bits which the dust cup can be attached to is as follows.

	Bit diameter
Dust cup 5	6 mm - 14.5 mm
Dust cup 9	12 mm - 16 mm

006406

There is another type of dust cup (accessory) which helps you prevent dust from falling over the tool and on yourself when performing overhead drilling operations.

Installing or removing the dust cup
1	2	1.	symbol
		2. Grooves
		3. Dust cup
	3
011506

Before installing the dust cup, remove the bit from the tool if installed on the tool. Install the dust cup (accessory) on the tool so that the symbol on the dust cup is aligned with the grooves in the tool.

1	1. Bit
	2. Chuck cover
	2
010733

To remove the dust cup, pull the chuck cover in the direction as shown in the figure and with the chuck cover pulled take the bit out of the tool.

1	1. Attachment at
	the foot of dust
	cup
010734

And then grab the attachment at the foot of dust cup and take it out.

1	1. Bellows
	2. Attachment
	2
011507

8