Makita HR2611F instruction manual Assembly, Torque limiter, Side grip auxiliary handle, Bit grease

For Models HR2310T, HR2610, HR2610T, HR2611F, HR2611FT

Rotation with hammering

1	1. Rotation with
	hammering
	2. Action mode
	changing knob
	2
010724

For drilling in concrete, masonry, etc., rotate the action

mode changing knob to the symbol. Use a tungsten-carbide tipped bit.

Rotation only

may no longer move in the symbol position. At this time, turn the tool on or turn the chuck by hand

in the symbol position and then rotate the action mode changing knob. Forcing the action mode changing knob may cause tool damage.

Torque limiter

The torque limiter will actuate when a certain torque level is reached. The motor will disengage from the output shaft. When this happens, the bit will stop turning.

CAUTION:

•	As soon as the torque limiter actuates, switch off
	the tool immediately. This will help prevent
	premature wear of the tool.
•	Bits such as hole saw, which tend to pinch or catch
	easily in the hole, are not appropriate for this tool.
	This is because they will cause the torque limiter to

1

010726

1. Rotation only

actuate too frequently.

ASSEMBLY

CAUTION:

•Always be sure that the tool is switched off and unplugged before carrying out any work on the tool.

Side grip (auxiliary handle)

For drilling in wood, metal or plastic materials, rotate the action mode changing knob to the symbol. Use a twist drill bit or wood bit.

Hammering only

1

1.Protrusions

2.Grooves

1

010725

1. Hammering only

2

010713

CAUTION:

•	Always use the side grip to ensure operating safety.
Install the side grip so that the protrusions on the grip fit
in between the grooves on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It

For chipping, scaling or demolition operations, rotate the action mode changing knob to the symbol. Use a bull point, cold chisel, scaling chisel, etc.

CAUTION:

•Do not rotate the action mode changing knob when the tool is running under load. The tool will be damaged.

•To avoid rapid wear on the mode change mechanism, be sure that the action mode changing knob is always positively located in one of the three action mode positions.

•When changing from the symbol mode to the

symbol mode, the action mode changing knob

may be swung 360° so as to be secured at any position.

Bit grease

Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 - 1 g).

This chuck lubrication assures smooth action and longer service life.

6