Turn the change ring in the direction of the arrow until the 1 mark on the change ring is aligned with 0 mark on the rubber cap to secure the bit.
Depth gauge
The depth gauge is convenient for drilling holes of uniform depth. Insert the depth gauge into the hole in the grip base. Adjust the depth gauge to the desired depth and then tighten the clamp screw to secure the depth gauge.
Depth gauge
NOTE:
The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing.
Switch action
To start the tool, simply pull the trigger. Tool speed is increased by increasing pressure on the trigger. Release the trigger to stop.
CAUTION:
Before plugging in the tool, always check t o see that the switch trigger actuates properly and returns to the "OFF" position when released.
