Makita HRIGODH instruction manual Reversing switch actionI, Selecting the action mode

Reversing switch actionI

This tool has a reversing switch to change the direction of rotation. Move the lever to the ' position for clockwise rotation or the * position for counterclockwise rotation

Switch trigger u

~

CAUTION:

Always check the direction of rotation before operation.

Use the reversing switch only after the tool comes to a complete stop. Changing the direc- tion of rotation before the tool stops may damage the tool.

Do not pull the switch trigger when the reversing switch lever is in the neutral position. If you pull the trigger forcibly, the switch may be damaged.

Selecting the action mode

This tool employs an action mode changing
knob. Select one of three modes suitable for
your work needs by using this knob. For
rotation only, turn the knob so that the arrow
on the knob points toward the		mark on
the tool body. For hammering only, turn the
knob so that the arrow on the knob points
toward the +mark on the tool body. For
rotation with hammering, turn the knob so
that the arrow on the knob points toward			\ 'Action mode
the	mark on the tool body.	/

changing knob

CAUTION:

The action mode changing knob may not be turned to your desired mode mark when the tool is not running. In this case, pull the switch trigger half-way and turn the knob while the tool is running under no load at low speed.

Always set the knob fully to your desired mode mark. If you operate the tool with the knob positioned half-way between the mode marks, the tool may be damaged.

I1