Makita JS1602 Specifications, Shear Safety Warnings, Explanation of general view

ENGLISH (Original instructions)

Explanation of general view

1	Slide switch	5	Loosen	11	Tighten
2	Gauge for stainless:	6	Upper blade securing bolt	12	No gap allowed
	1.2 mm (3/64")	7	Lower blade	13	Yoke
3	Gauge for mild steel:	8	Upper blade	14	Lower blade positioning screw
	1.6 mm (1/16")	9	Blade holder	15	Cutting line
4	Hex wrench	10	Thin washer

SPECIFICATIONS

Model				JS1602
	Steel up to 400 N/mm2			1.6 mm (16 ga.)
Max. cutting capacities	Steel up to 600 N/mm2			1.2 mm (18 ga.)
	Steel up to 800 N/mm2			0.8 mm (22 ga.)
	Aluminum up to 200 N/mm2			2.5 mm (13 ga.)
Min. cutting radius				30 mm
Strokes per minute (min–1)				4,000
Overall length				255 mm
Net weight				1.6 kg
Safety class				/II
• Due to our continuing programme of research and				GEB027-3
development, the specifications herein are subject to		SHEAR SAFETY WARNINGS
change without notice.
• Specifications may differ from country to country.		1.	Hold the tool firmly.
• Weight according to EPTA-Procedure 01/2003		2.	Secure the workpiece firmly.
	ENE037-1	3.	Keep hands away from moving parts.
		4.	Edges and chips of the workpiece are sharp.
Intended use
			Wear gloves. It is also recommended that you
The tool is intended for cutting sheet steel and stainless			put on thickly bottomed shoes to prevent injury.
sheet steel.		5.	Do not put the tool on the chips of the work-
	ENF002-2		piece. Otherwise it can cause damage and trou-
Power supply			ble on the tool.
		6.	Do not leave the tool running. Operate the tool
The tool should be connected only to a power supply of
			only when hand-held.
the same voltage as indicated on the nameplate, and can
		7.	Always be sure you have a firm footing.
only be operated on single-phase AC supply. They are
			Be sure no one is below when using the tool in
double-insulated and can, therefore, also be used from
			high locations.
sockets without earth wire.
		8.	Do not touch the blade or the workpiece immedi-
	GEA010-1		ately after operation; they may be extremely hot
General Power Tool Safety Warnings			and could burn your skin.
WARNING Read all safety warnings and all		9.	Avoid cutting electrical wires. It can cause seri-
instructions. Failure to follow the warnings and			ous accident by electric shock.
instructions may result in electric shock, fire and/or		10.	Do not operate the tool at no-load unnecessarily.

serious injury.	SAVE THESE INSTRUCTIONS.
Save all warnings and instructions for future
	WARNING:
reference.
	DO NOT let comfort or familiarity with product
	(gained from repeated use) replace strict adherence
	to safety rules for the subject product. MISUSE or
	failure to follow the safety rules stated in this instruc-
	tion manual may cause serious personal injury.

4