Table |
|
Lock lever | Handle |
|
Sawing
WARNING:
Risk of kickback (work piece is caught by the band saw blade and thrown against the operator.)
Do not jam any work piece.
•Select rip fence and table tilt for the type of cutting operation to be carried out.
•Set upper blade guide 3 mm above the work piece.
Note:
Always make a trial cut in a piece of scrap to verify settings, correct if necessary before cutting the work piece.
•Place work piece on the saw blade.
•Plug in.
•Start saw.
•Cut work piece in a single pass.
•Switch off if no further cutting is to be done immediately afterwards.
•Use separately retailed sub table.
Saw table tilt
CAUTION:
When
After loosening the lock lever the saw table tilts steplessly through 47º against the blade.
Turn the handle clockwise to tilt the table in an anticlockwise direction, and turn the handle anticlockwise to tilt the table in a clockwise direction.
Nut |
Large opening |
collector |
Small opening |
collector |
Connecting to vacuum cleaner
Cleaner operations can be performed by connecting the tool to Makita vacuum cleaner or dust collector.
If a dust extractor is fitted to the large opening collector, rearrange dust collector to ensure it has a large opening.
18
