15.Disconnect tools.
When not in use, before servicing and when changing accessories such as blades, bits and cutters.
16.Remove adjusting keys and wrenches.
Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on.
17.Avoid unintentional starting.
Do not carry a
18.Use outdoor extension leads.
When tool is used outdoors, use only extension cords intended for outdoor use.
19.Stay alert.
Watch what you are doing. Use common sense. Do not operate tool when you are tired.
20.Check damaged parts.
Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off.
21.Warning.
The use of any accessory or attachment, other than those recommended in this instruction manual or the catalog, may present a risk of personal injury.
22.Have your tool repaired by a qualified person.
This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user.
ADDITIONAL SAFETY RULES FOR TOOL
SAVE THESE INSTRUCTIONS.
1.Wear eye protection.
2.Don’t use the tool in presence of flammable liquids or gases.
3.Always use face or dust mask.
4.Check the blade carefully for cracks or damage before operation. Replace cracked or damaged blade immediately.
5.Use only saw blades recommended by the manufacturer and which conform to
6.Always use accessories recommended in this manual. Use of improper accessories such as abrasive
7.Select the correct saw blade for the material to be cut.
8.Do not use saw blades manufactured from high speed steel.
9.To reduce the emitted noise, always be sure that the blade is sharp and clean.
10.Do not cut metals such as nails and screws. Inspect for and remove all nails, screws and other foreign matter from the workpiece before operation.
11.Remove wrenches,
12.NEVER wear gloves during operation.
13.Keep hands out of the line of the saw blade.
14.NEVER stand or permit anyone else to stand in line with the path of the saw blade.
15.Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced blade.
16.Replace the table insert when worn.
17.Connect band saw to a
18.Do not operate the machine when the door or guard protecting the saw band is open.
19.Take care that the selection of the saw band and the speed depends on the material to be cut.
20.Do not clean the saw band whilst it is in motion.
3
