Makita RBC310, RBC230, RBC311, RBC260, RBC261 dimensions 11 80 mm ~1 2 0 mm 3-118 ~4-314

4.Hook the bent portion of the nylon cord into the notch in the center plate of the spool. Wind the nylon cords firmly and snugly on the spool in the direction of the "WIND CORD LH @" engraved on the spool.

(Note)

Do not wind the nylon cords in the opposite direc- tion of the "WIND CORD LH -''engraved on the spool. Do not overlap or twist the two nylon cords. They will not feed out properly.

5.Wind both nylon cords firmly and snugly until the spool is full to the outer edge of the center plate. Leave approx 120 mm (4.314") of both nylon cords unwound on the spool. Carefully prevent both nylon cords from coming loose on the spool. Pass the end of the shorter nylon cord out through the hole on the side of the rim of the spool and then back into the hole as illustrated. Pass the end of the other, longer nylon cord out through the hole on the opposite side of the spool as illustrated.

6.Pass the end of each nylon cord out through the eyelets on opposite sides of the housing. Place the spool into the housing. Pull the end of nylon cords while pressing down the spool.

7.Adjust the length of nylon cords so that each nylon cord extends approx. 8 0 mm - 120 mm (3-118" - 4-314") out of the housing. If the nylon cord extends out too much or does not extend out enough, adjust the length of nylon cord while raising the spool slightly within the housing.

11) 80 mm ~1 2 0 mm (3-118''~4-314")

12