For RBC260 and RBC310
The handle comes in three parts; t w o handles and one handle holder assembly. (One half of handle holder is already fitted t o pipe case, the other half of handle holder is in plastic bag with four socket head bolts). Place the t w o handles in the half of handle holder fitted to pipe case (the flared ends fit into grooves in handle holder). Place the loose handle holder over handles and other handle holder on the pipe case and fix together with the four socket head bolts, Ensure the throttle assembly is on correct side and before final tightening, adjust rake of handle to suit.
Route the throttle wire and ignition wires through locations on handle towards engine.
3.Assembly of throttle wire and ignition wire
Remove plastic cover from carburetor.
Insert throttle wire through adjusting screw and fit nipple of throttle wire into swivel of carburetor. Adjust the adjusting screw to take up free play of wire ensuring the throttle is fully opened when throttle lever is in high speed position and 2 ~3 mm (0.079" ~0.118") free play when in low speed position.
Connect the female and male bullet connectors from throttle assembly to the male and female bullet connectors coming from engine.
6
,