Makita UC 3000, UC 3500, UC 4000 manual Protective gloves must be worn

4/5

30°

E

-The file holder makes file guidance easier. It is marked for the correct 30° sharpening angle (keep the marks parallel with the chain when filing, see illustration) and limits the cut depth to the correct 4/5 of the file diameter. See "Accesso- ries" for the order number.

F G

-After having sharpened the chain, the height of the depth limiter must be checked by means of a chain gauge. See "Accessories" for the order number.

-Correct even the smallest excess height with a special flat file (F). See "Accessories" for the order number.

-Round off the front of the depth limiter (G).

Cleaning the guide bar lubricating the sprocket nose

CAUTION:

Protective gloves must be worn.

H

Regularly inspect the bearing surfaces of the guide bar for damage, and clean them with a suitable tool.

If the saw is used intensively it will be necessary to lubricate the return sprocket bearings regularly (once a week). To do this, first thoroughly clean the 2 mm hole at the tip of the guide bar, and then press in a small amount of multi-purpose grease.

Multi-purpose grease and grease guns are available as acces- sories.

Multi-purpose grease	(order no. 944 360 000)
Grease gun	(order no. 944 350 000)

15