Makita UH4570, UH6570, UH5570 Specifications, Symbol, EC Declaration of Conformity

ENGLISH (Original instructions)

SPECIFICATIONS

Model	UH4570	UH5570	UH6570
Blade length	450 mm	550 mm	650 mm
Strokes per minute (min-1)	1,600	1,600	1,600
Overall length	862 mm	970 mm	1,042 mm
Net weight	3.6 kg	3.7 kg	3.8 kg
Safety class		/II

•Due to our continuing programme of research and development, the specifications herein are subject to change without notice.

•Specifications may differ from country to country.

•Weight according to EPTA-Procedure 01/2003

END220-4

Symbol

The following show the symbols used for the equipment. Be sure that you understand their meaning before use. ･ Read instruction manual.

･ DOUBLE INSULATION

･ Do not expose to rain.

･ Remove plug from the mains immediately if the cable is damaged or cut.

･ Only for EU countries

Do not dispose of electric equipment together with household waste material! In observance of European Directive 2002/96/EC on waste electric and

electronic equipment and its implementation in accordance with national law, electric equipment that have reached the end of their life must be collected separately and returned to

an environmentally compatible recycling facility.

ENE014-1

Intended use

The tool is intended for trimming hedges.

ENF002-1

Power supply

The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire.

ENG102-3

Noise

The typical A-weighted noise level determined according to EN60745:

Sound pressure level (LpA) : 89.9 dB(A)

Sound power level (LWA) : 97.9 dB(A)

Uncertainty (K) : 1.5 dB(A)

Wear ear protection

ENG231-1

Vibration

The vibration total value (tri-axial vector sum) determined according to EN60745:

Work mode : hedge trimming

Vibration emission (ah) : 6.7 m/s2

Uncertainty (K) : 1.5 m/s2

ENG901-1

•The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another.

•The declared vibration emission value may also be used in a preliminary assessment of exposure.

WARNING:

•The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used.

•Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time).

ENH021-4

For European countries only

EC Declaration of Conformity

We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s):

2