1
2
009293
CAUTION:
1.Press the hooks on both sides
2.Unlock the hooks
Removing or installing shear blade
CAUTION:
•Before removing or installing shear blade, always be sure that the tool is switched off and unplugged.
•When replacing the shear blade, always wear gloves without removing blade cover so that hands and face does not directly contact the blade. Failure to do so may cause personal injury.
NOTE:
• | Do not wipe off grease from the gear and crank. |
•The blade cover (standard equipment) cannot be installed on the tool with the chip receiver being installed. Before carrying or storing, uninstall the chip receiver and then install the blade cover to avoid blade exposure.
NOTE:
•Check the chip receiver for secure installment before use.
•Never try to uninstall the chip receiver by an excessive force with its hooks locked in the blade unit grooves. Using the excessive force may damage it.
MAINTENANCE
CAUTION:
•Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance.
Cleaning the tool
Clean out the tool by wiping off dust with a dry or
CAUTION:
•Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result.
Blade maintenance
Smear the blade before and once per hour during operation using machine oil or similars.
After operation, remove dust from both sides of the blade with wired brush, wipe off it with a rag and then apply enough
CAUTION:
•Do not wash the blades in water. Failure to do so may cause rust or damage on the tool.
| Failure to do so may cause damage to the tool. |
• | For specific way of removing and installing shear |
| blades refer to the reverse of a package for |
| accessory shear blades. |
Removing the shear blades
Reverse the tool and loosen four screws.
| 1 | 1. | Screws | |
2 | 2. | Blade cover | ||
| ||||
009295 |
|
|
| |
NOTE: |
|
|
|
•Be careful not to get your hands dirty as grease is
applied in the shear blade driving area. Remove the under cover.
|
| 1. | Under cover |
1 | 2 | 2. | Blade cover |
009296 |
|
|
|
Remove the gear housing cover. |
|
| |
|
| 1. Gear housing | |
|
|
| cover |
| 1 |
|
|
009297 |
|
|
|
Set the crank at the angle as shown in the figure with a slotted bit screwdriver.
9
