Makita UM140DST manual

Installing the safety guard (safety cover)

Install the safety guard on the motor hous- ing as shown in the figure. Then secure the safety guard with the screw.

Installing or removing the blade

CAUTION :

Always be sure that the tool is switched off and the battery is disconnected form the tool before installing or removing the blade.

Installing the loop handle

Install the loop handle on the shaft at the desired position. Then secure the loop handle with the screw.

1 \ L S c r e w d r i v e r

handleLoop Safety guard

Align the notches in the cap and the blade retainer. Turn the cap and the blade retainer together counterclockwise to release the blade retainer from the pins.

Align notches	,Tighten
I

Blade retainer A

Adjusting the grip position

The grip position can be adjusted approx. 100 mm (3-15/16").Loosen the clamp screw and move the grip backward as de- sired for easy tool operation. Then tighten the clamp screw to secure the grip.

Shaft

I Gripd

L

Install the blades onto the pins.

Turn the cap and the blade retainer clock- wise until the pins fit into the holes in the blade retainer with a little click.

NOTE :

A set of spare blades can be kept in the storage area for them inside the grip.

I

I	Blade	Pin
		U

8

I Screw

erapS:blades

9