OPERATIONAL NOTES
INPUT
GAIN dB
50
55
60
65
MM
M
C
1
M C 2
MANLEY
STEELHEAD
LOAD
| x100 | CAP |
|
| x10 |
|
|
| pF |
|
|
|
|
4 | 5 | 6 |
| 4 | 5 | 6 |
|
|
| ||||
3 |
| 7 | 3 |
|
| 7 |
2 |
| 8 | 2 |
|
| 8 |
1 |
| 9 | 1 |
|
| 9 |
0 |
| 10 |
| 0 |
| 10 |
MC LOAD Z, ohms
0 | 100 | 2 |
| 0 | |
5 |
| 0 |
5 |
| 4 |
| 0 | |
2 |
| 0 |
|
|
|
|
|
|
|
| M | VOLUME |
|
|
|
|
|
| UTE |
|
|
|
|
|
|
|
| DI |
|
|
|
|
|
|
| M |
|
|
|
|
|
|
| S |
|
|
|
|
|
|
| U |
|
|
| LOAD |
|
|
| M |
| x100 |
| CAP |
| x10 |
|
|
|
|
| pF |
|
|
|
|
4 | 5 | 6 |
| 4 | 5 | 6 | LI |
|
|
|
|
|
|
| N |
3 |
|
| 7 | 3 |
| 7 | E |
2 |
|
| 8 | 2 |
| 8 |
|
1 |
|
| 9 | 1 |
| 9 | SLEEP |
0 |
| 10 |
| 0 |
| 10 |
PREPARATION FOR INSTALLATION
Budget a suitable space in which to place the preamplifier, power supply and associated interconnect cable. This space should be free of strong external magnetic and RF fields, and reasonably removed from strong
Make sure the power supply’s mains voltage selector switch is set to match the local line voltage, and the wire link is present between the preamp’s green CHASSIS and black CIRCUIT ground mini binding posts on the rear panel.
Try to position the power supply away from any interconnect cables which may be carrying audio signals.
BEFORE POWER-UP
Once placed, join the power supply cable to the
Proceed by connecting the input and output cabling to the signal sources and loads as desired. Tie any separate turntable or tonearm ground lead to the gold CHASSIS ground binding
Set the GAIN dB control to 55 dB and VOLUME control to about 9 o’clock. Choose the
MMor an MC input, as necessary, with the INPUT control. Place the LOAD Z switch to a value at or near that recommended by the cartridge manufacturer. Adjust the LOAD CAP switches to a value at or near that recommended by the cartridge manufacturer less any interconnect cable capacitance. Select and clean, if necessary, your favorite gramophone record....
Plug the power cable in and place the power supply’s mains power switch in the on () position. The STANDBY switch should glow. Push the STANDBY switch. The STANDBY switch will go dark, selected INPUT and GAIN blue LED’s will illuminate, the MUTE switch lamp will start flashing and the power supply pilot LED and the MANLEY STEELHEAD badge will light up.
Page 9