Extension cord chart (minimum cord gauge (AWG)
Length (metres) | .3 to 7.8 | 7.9 to 15.5 | 15.6 to 30.6 | 30.7 to 45.7 |
|
|
|
|
|
Cord gauge (AWG) | 18 | 16 | 14 | 12 |
|
|
|
|
|
17.Stay alert.
Watch what you are doing. Use common sense. Do not operate tool when you are tired, ill or under the influence of alcohol or other drugs.
18.Check damaged parts.
Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorised service centre unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorised service facility. Do not use the tool if the switch does not turn it on and off.
Don’t operate the machine with a damaged or excessively worn cutting device.
WARNING – DANGER 
LITTLE WONDER WILL NOT BE RESPONSIBLE FOR THE FAILURE OF CUTTING DEVICES OR ACCESSORIES THAT HAVE NOT BEEN TESTED AND APPROVED FOR USE WITH THIS UNIT. USE ONLY
19.The use of any accessory or attachment, other than those recommended in this instruction manual, may present a risk of personal injury.
20.Have your tool repaired by a qualified person.
This electric tool conforms to relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user.
21.Keep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property.
22.Work only in daylight or in good artificial light.
23.Keep all guards attached at all times when unit is operated.
24.Always use the shoulder strap.
Adjust the strap for comfort before starting the engine.
25.Secure unit during transport to prevent damage or injury.
26.Machine should not be used in any position that causes any part to come within 3 metres of overhead electrical lines. Always be aware of overhead power lines.
27.Always keep a firm grip on both handles when motor is running: one hand grasps the front “loop” handle while the other hand grasps the rear handle. Severe injuries can result if you try to use this machine with only one hand or with an insecure grip.
28.Thoroughly inspect the area where equipment is to be used and removed all objects, which can be thrown by the machine.
29.Always keep area clear of children, pets, and bystanders.
30.Always inspect your unit before each use and ensure that all handles, guards and fasteners are secure, operating, and in place. Be sure that all electrical cords are not damaged or broken.
31.Always maintain and examine your attachments with care. Follow maintenance instructions given in manual.
32.Don’t attempt to repair any part of the extended reach “E” system. Have repairs made by a qualified repairman. See that only original “Mantis” parts are used.
33.Maintain a firm footing and good balance, do not overreach while trimming. Before you start to trim, check the work area for obstacles that might cause you to lose your footing, balance or control of the machine. While operating the machine always be sure of a safe and secure operating position especially when using steps or a ladder. Always be sure of your footing on slopes.
WARNING – DANGER 
IMPROPER ASSEMBLY OF THIS EQUIPMENT CAN RESULT IN SERIOUS INJURY. MAKE SURE TO FOLLOW ALL INSTRUCTIONS CAREFULLY. IF YOU HAVE ANY QUESTIONS, CONTACT YOUR LOCAL AUTHORISED MANTIS DEALER.
34.Always disconnect power cord from power source:
a.Before cleaning blockages.
b.Before checking, cleaning or working on the cutting portion of the unit.
c.After striking a foreign object: inspect the cutting part for damage and make repairs before restarting and operating the unit.
d.If machine starts to vibrate abnormally (check immediately).
e.Whenever you leave the unit.
4
