35.Securing the extension cord.
Bend the extension cord about 40 cm from the plug end. Push that bend through the oblong opening, then loop the bend under the
cord retaining clips as shown. This will prevent the extension cord from detaching from the hedge trimmer plug.
Kickback
With a basic understanding of kickback, you will reduce or eliminate the element of surprise that may contribute to an accident.
Kickback may occur when the moving saw chain at the nose of the guide bar touches an object, or when the wood closes in and pinches the saw chain in the cut. In some cases, this may cause fast reverse action, kicking the unit up and back or down and back towards the operator. The operator can lose control of the device, and that could result in serous personal injury.
Keep a firm grip on the pruner handles at all time!
Assembling the Pruner (installing the saw chain)
WARNING 
DANGER 
CHAIN HAS A VERY SHARP EDGE, HANDLE WITH
CARE. ALWAYS WEAR GLOVES; OTHERWISE SERIOUS PERSONAL INJURY MAY RESULT!
1.Unscrew the mounting nut from the gear case cover. Open the cover. (Picture 3)
2.Mount the chain guide. Be sure that threaded pin fits into the opening in the guide bar. (Picture 4)
3.Fit the saw chain into the groove in the chain guide bar, and around the sprocket.
4.Be sure that pin of the chain tensioner fits into the lower hole of the guide bar. (Picture 4)
WARNING 
DANGER 
PAY ATTENTION TO THE CORRECT DIRECTION OF THE CHAIN SAW TEETH
5.Be sure the orientation of the chain is correct. (Pictures 5 and 6)
6.Hold it in place, and put gear case cover over the threaded pin. Attach mounting nut. Do not tighten. (Picture 7)
7.Adjust the tension of the chain and tighten the nut. (Picture 8)
Threaded pin
|
| Pin of |
|
| the chain |
|
| tensioner |
|
| Opening in guide bar |
|
|
|
Picture 3 |
| Picture 4 |
Correct direction of chain links
Picture 5
Direction of the chain movement
Picture 6 | Picture 7 | Picture 8 |
5
