Marantz PM7000 manual Operation, To Play AN Analog Record, To Listen to AN FM/AM Broadcast

English

!9Record (REC) Selector Switch

Use this switch to select recording between the tape deck and CD-R(MD) or recording of the signal selected by the INPUT SELECTOR SWITCH and output from the REC OUT jacks. See the note under "Tape Deck CD-R(MD) Operation on page 9 for full details about settings.

@0Source Direct Switch

Press this switch to turn source direct on (depressed) and off (raised).

When source direct is turned on, the audio signal path is as short and direct as possible in order to enjoy high-quality sources under the best conditions possible.

NOTE:

Tape and CD-R(MD) playback and recording are not possible when the SOURCE DIRECT switch is on. The TONE and BALANCE controls are also disabled. Any graphic equalizer or other such component that is connected to the PROCESSOR IN/OUT jacks will not have any effect. In order to use any of these components or controls, it is necessary to turn the SOURCE DIRECT switch off.

@1Bass and Treble Tone Controls

Use these controls to control the levels of their corresponding frequency bands. TREBLE adjusts the high frequency band, while BASS adjusts the low frequency band. Rotating a control towards (+) enhance the frequency band, while rotating towards (–) attenuates the frequency band.

@2Seaker Switches 1/2

Use these switches to turn speaker output on (depressed) and off (raised). You can turn off speaker output when listening to output over headphones.

@3Phones Jack

Use the jack to plug in headphones that are equipped with a standard phone jack.

@4Standby Indicator

This indicator is lit while the amplifier is in the Standby Mode. Pressing the remote control unit’s POWER buttons switches the amplifier between standby and power on.

OPERATION

1

3

INTEGRATED AMPLIFIER PM7000

INPUT SELECTOR

VOLUME

TAPE

PHONO

CD

TUNER

AUX1

AUX2

CD-R/MD

TAPE

MUTE

CD-R/MD

MIN

MAX

REC SELECTOR

BASS

TREBLE

BALANCE

POWER ON/OFF

PHONES

STANDBY

1 SPEAKERS 2

OFF

SOURCE DIRECT

SOURCE

TAPE CD-R

CD-R

TAPE

COPY

ON OFF

-

+

-

+

ON OFF

L

R

3

2Perform the applicable operation on the connected equipment.

TO PLAY AN ANALOG RECORD

1.Set INPUT SELECTOR to PHONO.

2.Play the record on the turntable.

3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.

NOTE:

•Be sure the set VOLUME to is minimum setting before placing the stylus onto the record or before replacing the turntable’s cartridge.

•Never subject the turntable to shock or vibration while a record is playing. This can cause the stylus to jump and possible damage the record.

•Locating your turntable too close to the speakers can cause howling, which will make it impossible to use higher volume settings.

•Never turn off power while the stylus is in contact with the surface of the record.

TO LISTEN TO AN FM/AM BROADCAST

1.Set INPUT SELECTOR to TUNER.

2.Tune in the desired station on the tuner.

3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.

TO PLAY A COMPACT DISK

1.Set INPUT SELECTOR to CD.

2.Play a CD on the CD player.

3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.

TO PLAY EQUIPMENT CONNECTED TO THE AUX 1 OR AUX 2 JACKS

1.Set INPUT SELECTOR to AUX1 or AUX2.

2.Set up the connected equipment for play.

3.Use VOLUME to adjust volume, and BASS and TREBLE to adjust the tone.

8