Playback Using the CUE Function
ENGLISH
Beginning playback from the CUE point
Procedure (Playback)
1.Press the CUE button !5.
The CD player immediately moves to the CUE point, and pauses there.
2.Press the button !7. Playback starts from the CUE point.
PMD331/PMD340 only:
If the CD player is in the paused state and the button !7is pressed, playback from the CUE point starts without any delay. This function is called “Instant Start.”
Tip:
It is easy to return to the CUE point after the point has been set. The concept of CUE play is illustrated below.
Press
Press
ENTER
SEARCH | PAUSE | PLAY |
| ||
| CUE | DISC |
| Point |
|
Erasing the CUE Point
Procedure (Erase)
1.Press the button !3to stop playback, and then press the
button !3again to erase the cue point. If the cue point is erased, the CUE button !5turns off.
CLEARCLEAR
Note:
The CUE point is also erased if you press the button y to open the disc tray w, or if you press the POWER switch q and turn the CD player off.
Resetting the CUE Point
Repeat the procedure described on page 12 in “Setting the CUE Point,” starting from step 1.
If the CD player is kept in the paused state for an extended
Period of time
If the CD player is left in the paused state for an extended period of time without performing any operations, it automati- cally enters the “auto standby” state.
In the auto standby state, the disc stops and “Standby” is indi- cated on the display.
To release the CD player from the auto standby state, press
the button !7.
When you press the button !7, the CD player searches for
the position that it was at previously and then pauses.
If you press the CUE button !5while the CD player is in the auto standby state, it searches for the CUE point and then pauses there.
Tip:
The amount of time the unit waits before if enters the “auto standby” state can be selected in the preset menu: 30 minutes (initial value), 20 minutes, 10 minutes, or 30 seconds.
13