![](/images/new-backgrounds/1251944/25194455x1.webp)
ENGLISH
Basic settings
This section describes the setting operations for basic settings available with the remote control.
The icons show the category of content applicable to each operation.
Video :
MPEG, AVI, WMV, AVCHD
Audio : Super Audio CD, CD,
WMA, AAC, LPCM
Photo : JPEG
Basic connections (vpage 10)
Playback (Basic operation) (vpage 16)
nn Changing the brightness of the display (Dimmer control) (vpage 24)
nn Playing
nn HDMI control functions (vpage 24) nn Video resolution (vpage 25)
nn Adjusting the picture quality (Picture control) (vpage 26)
nn Mode setting (vpage 27)
Changing the brightness of the display (Dimmer control)
The brightness of the display can be changed.
Press DIMMER.
• The brightness changes each time the button is pressed.
Normal
Dim
Dark
Off
• When the dimmer is set to off, the FL OFF indicator lights red.
Playing high-quality audio (Pure direct function)
This enables you to play high quality audio by stopping the video signal, etc., output, and outputting the analog audio signal only.
Press PURE DIRECT while stopped.
• The Pure Direct mode changes each time the button is pressed.
Pure Direct1
Pure Direct2
Off
HDMI control functions
When you make HDMI connections with a TV or AV receiver compatible with this unit and HDMI control functions, you can perform the following operations by setting up the HDMI control functions of each device.
• TV or AV receiver power is turned on by operating the unit and functions change with this unit input.
• Turning off the TV’s power turns the unit’s power to standby.
• Operating the unit via the TV’s remote control.
(When the TV’s remote control has player operation buttons)
1 Set the HDMI control function to “On”.
GUI menu “System” – “HDMI Control” (vpage 37).
2 Turn on all the equipment connected by HDMI cable.
3 Set the HDMI control function for all equipment connected by HDMI cable.
•Please refer to the user guides of connected devices for how to make settings.
•Carry out steps 2 and 3 if any of the equipment was unplugged.
4 To ensure that the unit’s HDMI video output is projected on the TV screen, change the input function of the TV and AV receiver.
5 When you turn the TV’s power to standby, check that the power of the unit and AV receiver also goes on standby.
|
| This turns off the digital audio output, video output, |
| Pure Direct 1 | |
| and display. And the FL OFF indicator lights red. | |
|
| |
|
| This turns off the digital audio output and video |
| Pure Direct 2 | |
| output. | |
|
| |
|
|
|
| Off | This turns off the pure direct function. |
|
|
|
•You cannot use PURE DIRECT while the GUI menu is displayed.
•The pure direct setting returns to “Off” when the unit is put in standby mode.
If the HDMI control function does not operate properly, check the following points.
•Is the TV or AV receiver compatible with the HDMI control function?
•Are the HDMI control function settings of all equipment correct? (Step 3)
•After setting, did you add another HDMI device connection or make any changes in the connections? If so make the settings again.
NOTE
•Some functions may not operate depending on the connected TV or AV receiver. Check the user guide of each device for details beforehand.
•When “HDMI Power Off Control” (vpage 37) is set to “Off”, the unit does not go to standby even if the connected device is in the standby mode.
24
The icons show the category of
content applicable to each operation.
Video Audio
Photo
For details of the media corresponding to each icon, see “Playable media” (vpage 48).