Marantz VC6001 Connecting Up, Easy setup, Connecting audio/video cables, Remote switch, See Note

2 Connecting Up

Easy setup

This easy setup is the minimum set of connections you need to start watching DVD-Video discs. Both sound and picture are fed directly to your TV using the supplied audio/video cables. For other possible connections, see pages 11 and 12.

Important

•Before making or changing any rear panel connections, make sure that all components are switched off and unplugged from the wall outlet.

•While a connected component is turned on, do not unplug the power cord of this DVD player from the wall outlet. The speaker may be damaged.

1	Connect to a				Connect to a pair of stereo		RS-232C terminal/
	composite video				2 audio inputs on your TV using		FLASHER IN
	input on your TV				the supplied Audio/Video cable.		Control terminal
	using the supplied				You can connect a subwoofer to		for use by custom
	Audio/Video				the SUBWOOFER Jack.		installers.
	cable.
		CENTER
	L			L
	R			R	COAX. OPT.		REMOTE CONTROL		AC IN
	FRONT	SUB W. SURR.		MIXED 2CH	DIGITAL		IN
			AUDIO OUT				RS-232C
								FLASHER INT. EXT.
							OUT	IN
	S1 VIDEO
	VIDEO OUT HDMI	Ver1.1	CR	CB	Y
				COMPONENT
					See Note:	EXT.	Plug into a
					INT.		3 standard AC wall
					Remote Switch
							outlet.

Connecting audio/video cables

Be sure to insert each plug fully for the best connection. The plugs and jacks are color-coded to make connection easier.

Connecting system control cables

By connecting this DVD player to another Marantz audio component using a supplied system control cable, you can remotely operate the components as a single system.

•When connecting to a component with a remote sensor, be sure to connect the REMOTE CONTROL IN jack of this DVD player to

the REMOTE CONTROL OUT jack of the component with the remote sensor.

•When connecting to component which is not equipped with a remote sensor, be sure to connect the component to the REMOTE CONTROL OUT jack of this DVD player.

Note

•When connecting to a standard TV, select

4:3 LETTER BOX or 4:3 PAN SCAN in the TV Aspect setting (see page 44).

•Connect the video output of the player directly to your TV. Because the player is designed

to support an Analog Protection System copy protection, there are cases when proper playback will not be possible if the player is connected to the TV through a VCR and images are recorded and played on the VCR.

•The player’s video output and S1 output are not be progressive.

•Remote switch

When using this DVD player independently, set this switch to INT. (INTERNAL). When using this DVD player in a system with a Marantz receiver equipped with a remote sensor, set the switch to EXT. (EXTERNAL). Change the switch setting using a pen with a sharp tip etc.

•Flasher Input

This is used when controlling components from different rooms with a keypad or other input device. Set the remote switch to EXT. (EXTERNAL) when using a flasher input.

10