®®
Once the MBB100 has been properly configured to connect to your LAN, you must configure the
connection to enable the MBB100 to receive information from an instance of N2KServer® or an
IPG100 Server. This is done through the following steps:
Figure 12 – N2KView® Window with Tabs Displayed
a. Click anywhere inside the N2KView® screen to display the screen tabs as shown in Figure 12
above.
b. Click on the “Connections” tab on the right side of the N2KView® screen to display the
Connections Settings dialog.
Revision 1.0 Page 11