17EASYTOUCH 35
To Clear all stored Learned Commands under a Mode:
1. Press and hold Setup key until the LED remains on (this occurs after approximately 2-3
seconds) and display shows the Main Setup Screen.
2. Release Setup key.
3. Press and release the Touchscreen "LEARN" Key.
4. Display will show the Mode Setup Screen. Press and release desired Mode key (TV,
VCR, SAT, etc.) on the rubber keypad. The LED will blink off once to indicate the
keypress acceptance.
5. Display will show the Learn Setup Screen. Press and hold the Setup Key until the
Main Setup Screen is displayed. All Learned Command entries under that Mode are
now cleared.
12 Marmitek X-10 Home Control The ET35 remote allows you to control all electrical appliances you have in your house. In
addition to transmitting infrared signals, which controls your TV, VCR, CD, SAT, CBL,
Audio and DVD, your remote is equipped with a radio transmitter sending Marmitek X10
signals, which will enable you to control lamps and electrical appliances from a distance.
Here are some examples of what you can do with your ET35 remote using home
control mode:
• Switch on/off, dim lights while you watch TV.
• Switch on the lights at night to frighten intruders when you detect something
suspicious.
• Switch on your electric blanket before the film ends to have it warm when you go to sleep.
To control your lamps or appliances, you will need additional home control modules.
The modules are simply plugged into AC outlets with no additional wiring required. Visit
www.marmitek.comfor more information.
To switch on/ off an appliance plugged into an home control module: Press the
key (2), then press the unit code of the home control module on the Touchscreen
display and then press CHAN+ / - (8).
To dim/bright a light plugged into a home control module: press its unit code on the
Touchscreen display and then press VOL+ / - (4).
To turn ON all the home control Lamp modules: Press the Power key (3).
To turn Off all the home control modules (Lamp and appliance): press the
Mute key (7).
12.1. Changing the home control House Code
The preset house code is A. In the majority of cases it is not necessary to change this
setting except if there is interference from neighbouring Marmitek X10 systems. In that
case:
ENGLISH