21EASYTOUCH 35
When pressed, a Channel Up command for the Current Mode code is sent once every 3
seconds. When any other key is pressed the scan will stop. Scanning will automatically
time-out after 2 minutes if no key is pressed.
5. VideoPlus/Showview Key SV/V+ (Touchscreen):
This key allows the User to directly access their VCR VideoPlus or Showview function if the
feature is available on their VCR. If VideoPlus or Showview feature is not available then
this key will allow direct access to any VCR Timer or Menu operation (if present) as an
alternative. The VideoPlus/Showview function is only available in VCR programmed
Modes. This key can be learned if required.
6. All Power Off Feature:
If the Power key is pressed twice within a 1 second period, and the second Power key-
press is held for more than 2 seconds, then the remote will send the Power command for
all Modes.
7. TV Volume/Mute Punch-Through:
The TV Volume/Mute punch-through feature allows the User to control the Volume and
Mute function of their Television in any Mode programmed to be a VCR (inc. DVD), Cable
or SAT library device without the need to change to TV Mode. This feature is also
available if the Marmitek X-10 Home Automation key is programmed to control a second
VCR, Cable or SAT device.
8. CBL/SAT Volume Control:
Some Cable and Satellite have their own volume control. By default in CBL/SAT modes,
the ET35 Volume and Mute key control the TV volume. To change the volume and mute
control either to TV or CBL/SAT for CBL/SAT mode, proceed as follows:
1. Press and release the TV mode key (TV must be in TV mode for this procedure).
2. Press and hold setup key until the LED remains on and the Main Setup Screen is
shown.
3. Release Setup key.
4. Press and hold the Mute key for approximately 5 seconds. The LED will blink, and
stay off for the 5 second period then blink once more to indicate volume toggle
acceptance. The display will return to the main Setup Screen.
5. Remote Volume default is now set.
14 Problems and troubleshooting
The remote doesn’t work or loses codes entered
• Confirm with your original remote that the equipment works correctly
• Make sure that you have pressed the corresponding mode key of the equipment or
device that you want to control.
• If the listed code does not work, try the AUTOSEARCH method or enter the next
code of that brand.
• To find the corresponding code for your equipment use the automatic search.
• Check that the batteries have the correct polarity position.
ENGLISH