Marmitek EasyTouch35

18 MARMITEK

1. Press the Marmitek X-10 Home Control key

2. Press and hold SETUP until the LED lights continuously.

3. Release the SETUP button.

4. Press the SETUP button again.

5. Use the digit keys on the Touchscreen display to enter the number equivalent to the

chosen home code (1=A, 2=B, ... 16=P).

6. Press ENTER followed by EXIT to confirm your command.

Note: The code you have chosen has to be the same as the one selected on the

Transceiver module TM13 or the security console, with which you use your remote.

12.2. Programming the Home Control IR/RF mode

Your ET35 remote control can control your electrical appliances using infrared signals (via

an infrared mini-controller IR7243) or RF signals (via a transceiver module TM13). The

key is set to RF mode by factory setting.

To program the key to send an Infrared signal, proceed as follow

1. Activate your ET35 remote by touching the screen

2. Press and hold the Setup key until the LED remains on (this occurs after approximately

2-3 seconds) and display shows the Main Setup Screen.

3. Release Setup key.

4. Press and release the Touchscreen "CODE" Key.

5. Display will show the Mode Setup Screen. Press and release Marmitek X-10 Home

Control key .

6. Display will show the Code Setup Screen. Enter 821.

7. Press and release the Touchscreen "EXIT" key to return to normal operation.