Ensure that the smoke detector is not installed directly on or near large metal objects as they can affect the radio range.
Before installing the SD10 smoke detector on your ceiling or the wall, ensure that the SD10 is within range of your Marmitek security system. You can test this by pushing the test button of the SD10. The Marmitek security system should now be triggered and will dial the pre- programmed telephone numbers.
In the case of range problems, choose a different location for your SD10 smoke detector. Moving the SD10 just a few centimetres can make a big difference in range.
To avoid false alarms, do not install the SD10 smoke detector in your kitchen, garage, in dusty places, in places with a higher than average air flow (near ventilation, open windows), near metal and in places where the temperature is below 10˚C or above 37˚C.
5 INSTALLATION
Please follow these steps to install the Marmitek smoke detector:
•Do not insert the battery at this stage (9V). Please follow the steps of the next chapter before you insert the battery. The smoke detector will not operate until you insert the battery properly.
•Remove the mounting bracket from your unit by rotating it
•In each of the keyhole slots, draw a mark to locate a mounting plug and screw.
•Remove the bracket.
•Drill two holes at the marks and insert plastic wall plugs. Ensure that the detector does not get any plaster dust on it when you drill the holes for mounting.
•Attach the bracket to the wall using the two screws and plastic wall plugs (supplied)
•Line up the slot of the bracket and the detector. Push the detector onto the mounting bracket and turn it clockwise to fix it into place. Pull outward on the detector to make sure it is securely attached to the mounting bracket.
6.REGISTERING THE SMOKE DETECTOR WITH THE SC9000 BASE STATION OF THE SAFEGUARD / TOTALGUARD
Carry out the following steps:
1. To access the menu, press the menu or menu button. The display will now read ‘ENTER PIN’.
2.Enter your
3.When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.
4.Press OK.
5.Insert the battery into the smoke detector (see the user manual of the smoke detector for more information). The console will beep to confirm. The display will read ‘RMOT x SET’.
SD10 | 5 |
