10 FINAL ASSEMBLY
The lower section of the smoke detector must be attached to the bracket already mounted on the ceiling and turned clockwise to the stop position.
11 CHANGING THE BATTERY
When the battery of the SD10 is almost empty, the SD10 will indicate this by beeping every 30 to 40 seconds. The sensor will continue beeping for a maximum of 7 days. Please change the battery immediately on hearing the signal.
12 FREQUENTLY ASKED QUESTIONS
Question: Does the siren of the smoke detector also go off if an alarm is triggered?
Answer: No. The siren in the smoke detector cannot be triggered via the alarm system. It will only go off when it detects fire/smoke.
Question: How many SD10 smoke detectors can I register?
Answer: Every SD10 is registered at the same address. There is no maximum number of smoke detectors.
Question: Can the alarm that indicates the battery is nearly empty be switched off?
Answer: No, because of safety considerations this signal cannot be switched off.
Question: Does every SD10 take up the place of a remote control when it is registered?
Answer: No, only the first SD10 you register will take up the place of a KR21. The other SD10s are registered at the same address.
Any questions?
Visit www.marmitek.com > Customer Service for the latest list of Frequently Asked Questions.
13 TECHNICAL DATA
Frequency: | 433,92 MHz |
Range: | Up to 30 meters. |
| The range is up to 10 meters in combination with the |
| HomeGuard MS8000. |
Alarm: | 85 dB |
Power supply: | 9V block battery, |
Operating temperature: | 10 to 37 degrees (Celsius) |
Air humidity: | < 95% rel. air humidity |
8 | MARMITEK |
