ASSEMBLY
NOTE: Assembly of the Prodigy requires 2 people.
1:Electrostatic Panel Assembly
1.1Remove the top two screws and washers from the Prodigy woofer body. Back out the two screws and washers immediately beneath the two screws that were just removed until they protrude approximately 3/4” from the woofer body. These screws must be in place in order to assemble the Prodigy.
With the electrostatic panel assembly leaning slightly towards you as you approach the woofer body, rest the lower open notches of the rear metal plate on the pair of protruding machine screws, making sure that the washers are on the top side of the metal plate.
1.2After resting the electrostatic panel assembly on the two protruding screws, it needs to be lifted up vertically so that the bottom aluminum trim will clear the woofer body when pivoted into place. Slowly pivot the electrostatic panel assembly into place.
NOTE: When the electrostatic panel assembly is in place, the aluminum trim on both sides of the bottom should be resting on top of the woofer body. Be careful to ensure that these aluminum pieces do not bite into the woofer body when the electrostatic panel assembly is screwed into place.
1.3Making sure the electrostatic panel assembly is being firmly held in place (we recommend having some- one else hold it), insert the top two screws and washers and thread them into place, reach in with the 5/32” allen wrench (included in instruction box) and tighten all four screws until they are firmly in place.
1.4Connect the electrostatic panel by aligning the line on top of the connector with the dot on top of the receptacle and gently pushing the connector into place. To remove the electrostatic panel connector, twist the end of the connector in the direction indi- cated by the arrow and gently pull it off.
NOTE: While playing, the Prodigy displays a blue light through the electrostatic panel. The button shown in step 1.3 will turn the light on or off, depending on your preference.
2:Front Grill Cloth
2.1Holding gently by the sides, attach the front grill cloth by first gently pushing the bottom into place—
2.2
NOTE: When the front grill cloth is in place, the stat panel connector should align with the notch in the top of the front grill cloth.
3:Rear Grill Cloth
3.1Holding gently by the sides, attach the back grill cloth by first gently pushing the top into place—
3.2
4Assembly
