FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Step 1: Verify door alignment
The door should be parallel to the sides and top of the refrigerator. If alignment is necessary the door may be adjusted by loosening the 2 screws which secure the hinge adapter brackets to the door and adjusting the door side to side. Use a 5/32” allen wrench for this pro- cedure. (See Figure 3 below).
Step 4: Cut overlay panel
Depending on the refrigerator model cut the overlay panel to the dimensions shown in Figure 4 and Table A below.
For overlay with lock option panel thickness to be
Hinge adapter screws loos- en these to adjust door, on the top and bottom of the door
Top hinge pin remove to remove the door.
9/32”
(7mm)
3/4” (19mm) maximum to 5/8” (16mm) miniumum.
Weight of the overlay panel should not exceed 20 pounds (9.1 kilograms).
For the door closer to work properly it is necessary to maintain a minimum space of 9/32” (7mm) between the door and cabinet flange as shown . This space can be adjusted by adjusting the top and bottom hinge adapters.
W
| Door must be | |
| parallel to top | |
Figure 3 | and sides of | |
refrigerator | ||
|
Step 2: Remove door
Remove the top hinge pin from the hinge with an 1/8” allen wrench. Remove the door by angling the top of the door outward and lifting the door off the bottom hinge. (See detail in Figure 3).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. Remove the door gasket by peeling up and out of the channel.
Front of |
|
|
|
overlay |
|
|
|
| H | ||
panel |
| ||
|
|
| |
|
|
|
|
|
|
|
|
Figure 4
Model | W | H | |
|
|
| |
30ARM | |||
(37.13cm) | (76.99cm) | ||
| |||
|
|
| |
61ARM | |||
(59.99cm) | (76.99cm) | ||
| |||
|
|
| |
6ADAM | |||
(59.99cm) | (70.33cm) | ||
| |||
|
|
|
Table A
Step 5: Clamp panel to door
Set the overlay panel on the door front, align the edges, and clamp together. Clamp the panel firmly but be care- ful not to crush the foam in the door or scratch the door.
12
