Unit care
•Avoid leaning on the cabinet and freezer doors. You may bend the door hinge or tip the unit.
•Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grille and/or light switch can occur.
•For cleaning of the appliance, mix a solution con- sisting of 2 tablespoons of baking soda with 1 quart of warm water or use a mild soap. Do not use strong cleaners or scouring powder or pads.
•Periodically empty ice bucket to replenish with fresh ice.
Important: When operation of the appliance is When operation of the appliance is to be discontinued for any length of time, the ice
to be discontinued for any length of time, the ice cube cavity in the icemaker should be emptied and cube cavity in the icemaker should be emptied and dried. The water supply and power supply should dried. The water supply and power supply should be shut off and the ice bucket should be emptied be shut off and the ice bucket should be emptied and cleaned.
and cleaned.
Things to Remember
•Allow 24 hours for your refrigerator and freezer to reach a new temperature setting.
•The unit will start and stop often. This is normal operation of the unit.
•Keep your appliance level for proper icemaker operation.
•Unplug the appliance before beginning any work to the unit.
•The refrigeration section can be colder or warmer using the adjusting slide located at the inside, left rear section of the unit.
Interior Light
Your appliance also features an interior light. It uses a
1.Unplug the power cord from the wall receptacle. Unless the unit is unplugged, the appliance light system remains energized even with the control knob in the "OFF" position.
2.Open the cabinet door.
3.Remove the 3 screws on the front face of the light lens and remove the lens.
4.Unscrew the light bulb from the socket and replace with an equivalent
5.Reassemble in the reverse order.
Electrical Fire Hazard
Under no circumstances replace with a bulb higher than 15 watts.
To clean the lens, disconnect the power cord and wipe the lens with mildly damp cloth. Dry the lens and light assembly completely before reconnecting the power cord.
Caution: Never pour liquids directly onto the the
light assembly..
3
