Marvel Industries 6CiM manual Remove Packaging, Note to Customer, Unit Installation Location

Remove Packaging

Your appliance has been packed for shipment with all parts that could be damaged by movement securely fas- tened. Before using, be sure all packing materials and tape have been removed.

Important

Keep your carton packaging until your appliance has been thoroughly inspected and found to be in good con- dition. If there is damage, the packaging will be needed as proof of damage in transit.

Note to Customer

This merchandise was carefully packed and thoroughly inspected before leaving our plant. Responsibility for its safe delivery was assumed by the carrier upon accept- ance of the shipment. As directed on the side of your packing carton, claims for loss or damage sustained in transit must be made on the carrier as follows:

Exterior Damage

Make thorough damage notation on your delivery receipt and have driver acknowledge by signature and date. Send a written request asking for an inspection report from carrier. Include the name of carrier representative and the date the inspection was requested. Retain inspection report and receipt for filing of a claim.

Concealed Damage

This must be reported to the carrier within fifteen days. Obtain inspection report from the carrier. Retain the inspection report for filing the claim. DO NOT RETURN DAMAGED MERCHANDISE TO MANUFACTURER - FILE THE CLAIM WITH THE CARRIER.

Unit Installation Location

Locate your appliance in the most convenient place near a grounded outlet. If possible, place your unit out of direct sunlight and away from heat sources such as a radiator, stove, oven, or furnace duct.

Your refrigerator has a fan-cooled condenser and can be built-in. No ventilation is required but the front grille must be kept clear for proper air movement and unit operation.

To build in, the opening must be at least 24"wide x 34- 3/4" high x 24" deep with ample provision for wiring. In addition, consideration should be given to the appli- ance's removal for routine cleaning and access to the waterline fittings.

Icemaker Plumbing

Observe and follow all local code(s) when installing appliance.

The only connection necessary to make the icemaker function is to connect the supplied copper water tube fit- ting to your home's cold water supply line.

Use ¼-inch copper water tubing only and the supplied connection fittings to connect to the water valve's ¾” garden hose fitting located at the rear of the unit. Additional connection parts are available at a local hard- ware-plumbing store. Water pressure must be at a mini- mum of 20 psi for proper operation.

Make certain all water connections are watertight after installation. Form the tubing so that it will not vibrate against the cabinet body or kink when your refrigerator is set in position.

Electrical and Grounding

The icemaker is already connected to the refrigerator's wiring. The appliance power cord must be connected to a power source of 120 Volts AC, 60 Hz, properly grounded 15 Amp circuit.

WARNING:THISUNITSHOULDNOTUNDER ANYCIRCUMSTANCES,BEBEUNGROUNDED..

ObserveCaution:and follow all local Electrical code(s) when Never pour liquids directly onto the

installing appliance.

light assembly.

1