CLEANING AND MAINTAINING
Condenser
The condenser tubing inside the cabinet does not require frequent cleaning; however, satisfactory cooling depends on adequate ventilation over the coils. Be sure that nothing obstructs the required air flow openings in front of the cabinet. At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grille on the bottom front of the cabinet.
Cabinet
The painted cabinet can be washed with mild soap and water and thoroughly rinsed with clear water. Never use abrasive scouring powders.
Interior
Wash interior compartment with mild soap and water. Do not use an abrasive powder, solvent, polish cleaner or undiluted detergent.
Glass Door
Use a glass cleaner or mild soap and water and soft cloth to clean the glass door model. Do not use any abrasive powders.
Door Gasket
The vinyl gasket may be cleaned with mild soap and water, a baking soda solution or a mild scouring powder.
Light Tube Replacement
WARNING! DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT TUBE REPLACEMENT. Failure to do so may result in an electrical shock that could severely injure you.
This product uses two, 6 watt light tubes to illuminate the interior of the unit. The light tubes are very reliable electrical components, but should either or both light tubes not function properly, please call the dealer you purchased your unit from for replacement light tubes. Use only original equipment light tubes from your dealer or manufacturer.
Light tube replacement consists of using a small phillips head screwdriver to remove the two screws that hold a cover plate over the back section of the light tube. Set the screws and cover plate aside for
Using a small
Disconnect the two insulated electrical connectors from the cabinet’s electrical cable and discard the old light tube. Reconnect the insulated electrical connector of the new light tube to the cabinet’s electrical cable connectors. Make sure they are secure and fully inserted.
Carefully realign the light tube’s electrical terminals back into the rear of the light enclosure channel making sure not to crimp them. Gently insert the light tube along the length of the light enclosure channel. Press the light tube gently into the light enclosure channel. Only a small part of the light tube should project below the ceiling of the unit. DO NOT USE A HAMMER TO FIT THE LIGHT TUBE.
Place the light tube terminal cover plate back in its original position on the light enclosure’s flange.
The light tubes are not covered by your guarantee. Replacement tubes can be obtained from your service provider or from Marvel Industries.
All specifications and product design subject to change without notice.
Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products.
5
