Before You Begin
Installer and Builder Information
SRead these instructions thoroughly BEFORE beginning to install your Marvin window product.
SAlways provide a copy of these instructions for the current or future building owner.
SPlan sizing of rough opening and clearance from exterior finishing systems to allow for normal materials shrinkage or shifting (e.g. wood structure with brick veneer, allow adequate clearance at sill). Failure to do so can void the Marvin warranty coverage.
SRefer to the Technical Installation Specifications section for technical specifications regarding the installation of this product. These installation requirements as well as the details in this section must be followed to achieve the advertised design pressure (DP) rating of this product.
S It is the responsibility of the builder, installer and subcontractors to protect the interior and exterior of windows or doors from excessive contact with harsh chemical washes, construction material contamination and moisture. Damage to glazing, hardware, weatherstrip and cladding/wood can occur. Protect with painters tape and/or protective sheathing as required. Follow all guidelines regarding material use, preparation, personal safety and disposal.
SRefer to the enclosed painting and staining instructions on the last page for exterior and interior finish instructions.
SContact your Marvin supplier if you have any questions regarding product and materials used in manufacturing or questions on replacement parts.
Aftermarket Products
Alterations to Marvin products including window films, insulating or reflective interior window treatments or additional glazings can cause excessive heat buildup and/or condensation. They may lead to premature failures not covered under warranty by Marvin Windows and Doors.
Before purchasing or applying any product that may affect the installation or performance of Marvin windows contact the manufacturer of aftermarket product/glazings that are not supplied by Marvin and request written product use, associated warranties and damage coverage. Provide this information and warranties to the end user and/or building owner for future reference.
Hazard Notations
Please familiarize yourself with the following hazard notations used throughout this instruction.
Icon | Description | Usage |
| Caution | Mistakes or misuse could cause damage to the window or result |
| in faulty installation and unit performance. | |
|
| |
| Warning | Mistakes or misuse could result in personal injury and/or |
| severe damage to unit, equipment, and/or structure. | |
|
| |
| Seek | Help from another individual is necessary to perform this task |
| Assistance | safely and correctly. |
| Tips/Hints | Information on alternative procedures, definitions, helpful hints. |
You Will Need to Supply
Safety glasses | Hearing protection |
Level | Square |
Hammer | Wood shims |
Fiberglass insulation | Tape measure |
Perimeter sealant1
Backing material (foam backing rod) Low expansion foam insulation2 Appropriate fastener (see fastener chart) Construction adhesive3
NOTE: Numbers listed in parentheses ( ) are metric equivalents in millimeters rounded to the nearest whole number.
Standard Parts Shipped
Units are sent with hardware; clad units are sent with four (4) nailing fin corner gaskets. Follow installation instructions included with part if applicable. UDHM units are sent with a fastening package and supple- mental installation instructions.
NOTE: Depending on the installation method, other material may be needed to properly prepare and seal the installation such as self sealing adhesive mem- brane, building paper, and seam seal tape, etc.
WARNING: Always practice safety! Wear the appropriate eye, ear and hand protection, especially when working with power tools.
1Sealant must be Grade NS Class 25 per ASTM C920 and compatible with building exterior and window surface.
2Optional, use low expansion foam insulation only. Foam and foam application must comply with ASTM E2112, section 5.9.2. 3APA rated
3
