Master Appliance 1425-3550 FPM130-900F Important Safety Instructions cont’d, not cause tipping

Important Safety Instructions (cont’d)

clothes. Wash hair and body thoroughly with soap and water.

12.WARNING: To reduce the risk of fire or electric shock, do not expose heat guns to rain or moisture. Store indoors. Connect to grounded outlet only.

13.Do not use plug adapters or remove the ground prong from the plug. This tool is equipped with a 3-prong plug and a 3-wire grounding system. Connect to properly grounded outlets only.

14.Use heat gun only on adequately rated circuits to avoid overheating of electrical systems.

15.Proheat heat guns can produce up to 1050°F of flameless heat out of the nozzle. Do not direct this hot air stream at your clothing, hands or body parts. Do not use as a hair dryer.

16.Do not touch nozzle opening or nozzle shield until cool. When in “Hot” mode, extreme heat is generated at those areas. Always hold tool by the handle or use permanently attached stand.

17.Run on cool before turning off. The nozzle and shield require approximately 3 minutes to become cool to the touch. Stand the unit on its end with the nozzle pointing upward after turning off.

18.Do not touch work surface with nozzle. Scrape paint

with nozzle face at least 1” away.

19.Keep a clean work area. Messy or cluttered work areas invite accidents or injury.

20.Keep away from children. All visitors should be kept at a safe distance from the work area. Do not let visitors touch the tool or extension cord.

21.Use tool in a well-ventilated area. Do not use near flammable liquids or in an explosive environment (where fumes, gases or dust are present).

22.Remove all highly flammable materials and other debris from the work area.

23.Wear safety glasses at all times.

24.When using an extension cord, use only a 3-wire grounded cord with a minimum of 14-gauge capacity. We recommend they be listed by Under- writers Laboratories (UL) in the U.S.A. or (CSA) Canadian Standards Association in Canada and be suitable for outdoor use. Cords marked for outdoor use are also suitable for indoor use.

25.Don’t abuse cordset. Never pull by cord to remove from electrical outlet or carry tool by cord.

26.When not hand-held, place tool on a level surface. Position cordset so it does

not cause tipping.

27.Keep a fully-charged fire extinguisher close at hand.

28.Do not leave heat gun unattended while it is running or cooling down.

29.Stay alert. Do not operate tool when you are tired. Use common sense and watch what you are doing.

30.Store properly. Do not store while hot. Store in a dry, high or locked-up location. Keep out of the reach of children.

31.Always unplug tool before performing any maintenance. When servicing, use only Master Appliance brand replacement parts. We recommend that all maintenance be performed by a qualified repair technician who is experienced in the repair of electric tools, a qualified service organization, or our repair staff.For Factory Repair Service, send product to:

32.WARNING: This product when used for soldering and similar applications, produces chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.

Master Appliance Corp.

Attn: Repair Department

2420 - 18th Street

Racine, Wl 53403

Save These Instructions.

4