Master Lock BR150CE owner manual Ventilation Operation, To Start Heater

VENTILATION

OPERATION

WARNING

Follow the minimum fresh, outside air ventilation requirements. If proper fresh, outside air ventilation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, outside air ventilation before running heater.

Provide a fresh air opening of at least 2800 square cm (three square feet) for each 100,000 Btu/Hr rating. Provide extra fresh air if more heaters are being used.

Example: A 150,000 Btu/Hr heater will require at least 4,200 square cm (4.5 square feet) fresh air opening.

WARNING

Review and understand the warnings in the Safety Information Section. They are needed to safely operate this heater. Follow all local codes when using this heater.

To Start Heater

1.Follow all ventilation and safety information.

2.Fill fuel tank with kerosene or No. 1 fuel oil.

3.Attach fuel cap.

4.Plug power cord of heater into standard 220 volt/50 hertz, grounded (earthed) outlet. Use an extension cord if needed. Use only a three-prong, grounded (earthed) extension cord.

Extension Cord Wire Size Requirements

Up to 30.5 meters (100 feet) long, use 1.0 mm2 (16 AWG) conductor

30.6 to 61 meters (101 to 200 feet) long, use 1.5 mm2 (14 AWG) conductor

Heater will start when power cord is plugged into outlet. If not, push in flame- out control reset button (see Figure 5).

5.Adjust thermostat to desired setting. If heater does not start, thermostat may be set too low. Turn thermostat knob to higher position to start heater. If thermo- stat is in HIGH position and heater still will not start, push in flame-out control reset button (see Figure 5).

Flame-Out Control

Reset Button

Figure 5 - Flame-Out Control Reset Button

Continued 7

102384