GRILL OPERATION CAUTIONS
•Avoid bumping or impacting grill.
•Keep your hands, hair and face away from burning charcoal.
•This grill has an open flame. Be careful of loose hair and clothing during operation. They may catch fire.
•Use protective gloves when handling this grill or working with fire. Use protective gloves or long, sturdy fireplace tools when adding wood or charcoal.
•Do not allow anyone to conduct activities around this grill during or following its use until the unit has cooled. This grill is HOT during operation and remains HOT for a period of time following its use.
•Fatty foods like hamburgers can have excess grease that can cause flare ups. When cooking fatty foods, use caution when opening lid and during cooking to avoid being burned.
•Be careful when removing food from grill. All surfaces are HOT and may cause burns. Use protective gloves or long, sturdy cooking tools.
•Never use glass, plastic or ceramic cookware on this grill.
•The use of alcohol, prescription or
•Grill lid and base are HOT while in use and during cooling process.
•Do not remove ash can while ashes and charcoal are HOT.
•Air dampers are HOT while the grill is in use and during cooling; wear protective gloves when adjusting.
•Never overfill charcoal grate. This can cause serious injury as well as damage the unit.
•Only use charcoal lighting fluid, never use gasoline, alcohol or other highly volatile fluids to ignite the charcoal. These fluids can explode causing injury or death.
REMINDER:
NEVER OPERATE THIS GRILL UNDER ANY OVERHEAD CONSTRUCTION. MAINTAIN A MINIMUM DISTANCE OF 10 FEET FROM OVERHEAD CONSTRUCTION, WALLS OR RAILS.
SEE DIAGRAM BELOW.
Overhead | 10 feet | |
Construction | ||
| ||
| Rails | |
Wall | 10 feet | |
|
Before assembly read instructions carefully.
Tools needed for assembly:
Adjustable Wrench
Phillips Head Screwdriver
F7
Assemble grill on a clean, flat surface.
E
Do not tighten screws all the way. Legs may need to be adjusted when
A 
leg support frame is attached in
STEP 2.
STEP 1.
Place heat insulation washers (F) on leg (7) as shown. Secure with aluminum flat washers (E) and phillips head screws (A).
Repeat step with remaining legs.
STEP 2.
Note: Leg support frame may require tilting to place in position.
Note: Legs may need to be spread apart to place leg support frame in position.
Position corners of leg support frame (4) inside legs above clips as shown. Press leg support frame down firmly into clips to secure.
Tighten all leg hardware.
4
Leg Clip
7 | 4 |
