SOAPY WATER TEST WARNING AND PROCEDURES
•The Soapy Water Test must be performed each time the gas cylinder is connected to your grill or each time the grill is used.
•The Soapy Water Test must be performed outdoors in a
•When performing the Soapy Water Test, always keep grill away from open flames, sparks, or lit cigarettes. Never use an open flame to test for gas leaks.
•This product will not operate with natural gas.
PROCEDURE:
1.Turn gas control valve to OFF position, and turn the gas cylinder valve to the OFF position.
2.Prepare your soapy water solution by combining (1) one part dish washing liquid with (3) three parts water to test for the possibility of any gas leaks in the hose or connections to regulator and the regulator connection to gas cylinder. Apply soapy water solution to the gas cylinder valve, regulator and up the hose to the grill hose connection.
BURNER LIGHTING INSTRUCTIONS
1.Read all instructions and warnings before lighting
2.Check the gas control valve and gas cylinder valve to be certain it is in the OFF position before connecting to the gas cylinder. perform soapy water test before each use.
3.Open lid during lighting
4.Turn gas control valve OFF, turn gas cylinder valve on
5.Push down knob and turn to 'ignite' and light
6.Repeat up to three time if necessary
7.If ignition does not take place immediately, wait five minutes and then match light. See match light instructions below.
8.After each use, first turn the gas control valve off first, then the gas cylinder valve off. Always allow grill to cool completely before touching, moving, or storing.
CAUTION: Fatty foods (like hamburgers) can have excess grease and can cause flare up. When cooking fatty foods, use a low setting with lid open.
MATCH LIGHTING INSTRUCTIONS
3.Turn gas cylinder valve ON (gas control valve is in the OFF position) and observe gas cylinder valve, hose and regulator for bubbles. DO NOT LEAVE GAS ON FOR MORE THAN 12 SECONDS. If bubbles appear, stop, turn gas cylinder OFF, and retighten the fitting. Repeat test.
Bubbles in Soapy Water Test
1. | Read all instructions and warnings before lighting |
2. | Check the gas control valve and gas cylinder valve to be certain it |
| is in the OFF position before connecting to the gas cylinder. |
| perform soapy water test before each use. |
4.When the test is complete, and there are no leaks, wait a minimum of 5 minutes for gas fumes to diminish before lighting cooker.
3. | Open lid during lighting |
4. | Turn gas control valve OFF, turn gas cylinder valve on |
DURING ANY PORTION OF THE SOAPY WATER TEST, IF BUBBLES CONTINUE TO APPEAR, STOP, DO NOT USE THE GRILL AND CONTACT YOUR LOCAL PROPANE DEALER OR MASTERBUILT AT
Before each use perform soapy water test. Before each use, inspect
gas hose for any signs of abrasion, cuts, leaks, or wear. If replacement is needed, contact Masterbuilt Manufacturing
for regulator hose model #BPRLP19.
6
5.Push down knob and turn to low setting
6.Place a lit fireplace match through lighting hole in side of grill.
7.After each use, first turn the gas control valve off first, then the gas cylinder off. Always allow grill to cool completely before touching, moving, or storing.
WARNING:
Always visually check burner ignition to avoid gas leeks.
7
