HYDRAULIC SYSTEM CHARGING PROCEDURE
1.Set handles in the neutral position.
2.Start engine at idle.
3.Let run for a minimum of 30 seconds.
4.Stroke handles to forward position.
5.If motors do not turn in 15 seconds return handles to neutral and repeat step 3 and 4 (one time).
6.If motors do not turn after second attempt, shut off the engine and check for oil at the pump.
7.Increase throttle to half speed and work handles through forward and reverse position until the motor operates smoothly throughout the entire speed range.
Note:
Seal Kit for hydraulic pump; 784983 (BDP21L Overhaul Seal Kit)
108604 10/08 |
