Maxi-Cosi Car Seat manual Installing the PrioriFix

				• Installation with 3-point safety belt	Yes
3
				• Installation with 2-point safety belt	No
		1	2
1
	2
				• On passenger seat	Yes
				• On left/right side of back seat	Yes
				• In middle position of back seat	Yes*	GB
				• Rear-facing	No
				• Forward-facing	Yes
				• Belt routing marking	Red
				• Frontal airbag	No
				• Side airbag	Yes

*Provided there is a 3-point safety belt in the middle position of the back seat and there is enough room for properly installing the support leg. Check car fitting list.

Only install the PrioriFix on a forward-facing seat fitted with an automatic 3-point safety belt approved in accordance with ECE R16 or equivalent standard.

The proper threading of the seat belt is essential to your child’s safety. The seat belt must be threaded along the red markings on the PrioriFix. See the sticker outlined in red on the side of the PrioriFix. Never thread the belt in any other way!

16

17

18

19

2021

21

A. Installing the PrioriFix

•IMPORTANT! Make sure the Isofix connectors are retracted.

•Press the central button on the support leg (16,1) and pull the support leg forward as far as possible (16,2).

•IMPORTANT! Secure any fold-down seats.

•IMPORTANT! On some seats, the belts are fitted so far forward that proper installation is not possible. If this is the case, try another seat.

•IMPORTANT! In some cases, the buckle of the car belt may be too long and therefore sits too high against the base of the PrioriFix. The PrioriFix can therefore not be fitted securely. If this is the case, choose another position in the car.

•Place the PrioriFix in the sleeping position on the seat of the car (17) with the support leg folded out.

•Thread the seat belt between the shell and the base (18).

•Make sure that the lap belt section of the seat belt is threaded under the red lap belt markings.

•Insert the seat belt into the belt buckle of the car (19).

•IMPORTANT! Make sure the car seat belt is not twisted.

•Place the car shoulder belt in one red belt clamp (20) on one side only (depending on the position of the PrioriFix in the car) and fasten it (21,1).

•Push the PrioriFix firmly into the car seat (21,2) while at the same time pulling the shoulder belt tight (21,3) so that the PrioriFix is securely in place. Double-check it!

•Adjust the shell of the PrioriFix to the sitting position (see section 4.2: Seat positions).

B. Adjusting the length of the support leg

• See section 3.1, point C: “Adjusting the length of the support leg”.

Instructions for use

11