Maxi-Cosi Priori manual Locking Clip Rear-Facing Only

4358-4274 US Priori 5/25/07 8:33 AM Page 25

Locking Clip:

Rear-Facing Only

NOTE: Remove the locking clip when the seat belt is not being used with a child restraint. The locking clip is located on the recline foot. A locking clip will not fix all types of seat belt problems. The locking clip is not used in the forward-facing mode of use because this child restraint uses shoulder belt lock-offs.

Before you put your child restraint in the vehicle in the rear-facing mode of use, buckle the lap/shoulder belt. Pull on the lap belt portion. If it loosens or slips, you must either use a locking clip to hold the seat belt tight or move the child restraint to another seating location.

3	Thread both
	portions of the
	vehicle belt onto
	the locking clip.

Position locking clip about 1 in. (2.5 cm) from vehicle

1

Thread both vehicle lap and shoulder belts through the slot (as shown) and out other side. Buckle. Pull up on shoulder belt until all slack is out and lap belt is tight.

belt’s buckle plate.

Grasp both vehicle

2belts together just behind the buckle

plate and unbuckle. NOTE: If the buckle

plate ends up behind the child

restraint, grasp the belts to the outside

of the child restraint, as close to the buckle plate as possible.

5	Rebuckle belt. Lap
	belt portion should
	now be tight. If
	not, remove
	locking clip and
	repeat all steps.

22 23