Maxi-Cosi Priori manual Rear-Facing Installation with Vehicle Belt

4358-4274 US Priori		5/25/07	8:33 AM	Page 29
5		When LATCH is
		not being used,
		fasten LATCH
		hooks on side of
		child restraint as
		shown.
		Do Not Use the top
		anchorage strap in
		the rear-facing
		position.
		Hook top
		anchorage strap to
		recline foot (see
		“Adjusting the Top
		Anchorage Strap”
		section).
!	WARNING:

A loose top anchorage (tether) strap can result in serious injury or death.

Loose LATCH hooks can result in serious injury or death.

Rear-Facing Installation with Vehicle Belt:

1	Place child
	restraint rear-
	facing in the back
	seat. With child
	restraint in the fully
	reclined position,
	make sure level
	line on side of
	shell is level with

ground. Adjust child restraint if needed.

NOTE: Hook top anchorage strap to recline foot (see “Adjusting the Top Anchorage Strap” section).

2	Thread the
	vehicle lap or
	lap/shoulder belt
	combination
	through the rear-
	facing belt slot.

Rear Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm)

3

Thread UNDER seat pad behind the crotch strap, between crotch strap and rear harness slot, and out opposite side. Buckle vehicle belt.

Do not place vehicle belt over child’s legs.

26 27 continued on next page.