MNP/V.42/V.42bis Commands | MaxTech V.34/V.42bis specs

	d=300-28800. A, b, c, d default=11, 1,
	300, 28800. Parameter “a” specifies the
	modulationprotocoldesiredwhere:0=V.21,
	1=V.22, 2=V.22bis, 3=V.23, 9=V.32,
	10=V.32bis, 11=V.34, 64=Bell 103,
	69=Bell 212, and 74=VFC. Parameter “b”
	specifies automode operations where:
	0=automode disabled, 1= automode
	enabledwithV.8/V.32AnnexA.Parameter
	“c” specifies the minimum connection data
	rate (300-28800). Parameter “d” specifies
	themaximumconnectionrate(300-28800).
#CID=n n=0	Disable Caller ID
n=1	Enables Caller ID with formatting (date,
	time, number, name)
n=2	Enables Caller ID without formatting
#CID?	Displays current Caller ID mode
#CID=?	Returns Caller ID capabilities of modem.

3.5 MNP/V.42/V.42bis Commands

%C_	%C0	Disable MNP Class 5 and V.42bis data
		compression
	%C1	Enable MNP Class 5 data compression
		only
	%C2	Enable V.42bis data compression only
	%C3	Enable MNP Class 5 and V.42bis data
		compression
&Q_	&Q0	Direct data link only (same as \N1)
	&Q5	V.42 data link with fallback options
	&Q6	Normal data link only (same as \N0)
\A_	\A0	64-character maximum MNP block size
	\A1	128-character maximum MNP block
		size
	\A2	192-character maximum MNP block size
	\A3	256-character maximum MNP block size
\Bn	Send a 1/10 second line break to the modem,
	where n = 1 to 9. At normal connect, the default
	is 3
\Kn	Set break control, where n= 0 to 2. The effect of
	this command depends on the modem’s operating
	condition. Default is 1.
\N_	\N0	Normal data-link only
	\N1	Direct data-link only